Looking for faster way for configuring or programming Altera FPGAs? Use SLS USB BitJet - A High Speed download cable which can program, configure or debug Altera FPGA based hardware systems at much Faster Speed.

The USB BitJet download cable interfaces a USB 2.0 port on a host computer to an Altera FPGA mounted on a printed circuit board. The cable sends configuration or programming data from the PC to a standard 10-pin JTAG or Active Serial header connected to Altera FPGA. You can use the USB BitJet download cable to iteratively download configuration or programming data to a system during prototyping or production.

Features:

• Download configuration data to Altera FPGA devices
  • Stratix^® series FPGAs
  • Cyclone^® series FPGAs
  • Max^® series CPLDs
  • Arria^® series FPGAs
• In-system programming of the following devices :
  • Serial configuration devices including EPCS1, EPCS4, EPCS16, EPCS64 and EPCS128 devices
• Perform Signal Tap^® II logic analysis
• Supports target systems using 3.3 V LVTTL/LVCMOS and single-ended I/O standards from 1.5 V to 3.3 V
• Supports communication and debugging of the Nios^® II embedded processor family

Power Requirements:

• 5.0 V from the USB cable
• Between 1.5 V and 3.3 V from the target circuit board

Software Requirements:

• Windows XP (32-bit and 64-bit) with service pack 2, Windows Vista, Windows 7 and Windows 8 (32-bit and 64-bit) systems
• Quartus II Programmer (for programming and configuration)
• Quartus II SignalTap^® II Logic Analyzer (for logic analysis)
• Quartus II Programmer (standalone version)
• Quartus II SignalTap II logic analyzer (standalone version)

Deliverables:

• Installation CD
  • Drivers for Windows XP with SP2, Windows Vista, Windows 7 and Windows 8 32/64 bit
• USB Cable

Downloads:

• USB BitJetLite (High Speed) Documents

Note: ^® indicates registered mark of Altera Products